ArticleMaterials (Basel, Switzerland)2026
Microstructural Evolution and Mechanical Properties of Investment-Cast Haynes 282 Nickel-Based Superalloy After Heat Treatment and High-Temperature Thermomechanical Processing.
Article in Materials (Basel, Switzerland), 2026. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
3 authors.
Funding
Abstract
This study analyzed the effect of a processing sequence comprising precision casting, heat treatment, and high-temperature plastic deformation on the microstructure and mechanical properties of the Haynes 282 nickel superalloy. The starting material was prepared in an industrial VIM IC induction furnace under vacuum conditions; the quality of the resulting castings, phase composition, thermal effects, and the alloy's behavior during uniaxial compression were then evaluated. Castings in the form of rods with diameters of 10, 12, and 16 mm were produced at a molten alloy temperature of 1550 °C and a ceramic mold temperature of 1250 °C. The lowest porosity values, ranging from approximately 0.036-0.16%, were obtained for the vacuum furnace cooling variant, which was selected for further testing. DTA analysis revealed characteristic thermal effects in the range of 935.9-1379.8 °C, which enabled the selection of supersaturation parameters and a safe range for deformation tests. After supersaturation and aging, the samples were compressed at temperatures of 700-1200 °C at strain rates of 0.001 s
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.