ArticleSensors (Basel, Switzerland)2026
Subpixel Edge Localization via Ruled-Sigmoid Surfaces and Its Application for Precision Analysis of Cycloidal Gear Profiles.
Article in Sensors (Basel, Switzerland), 2026. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
4 authors.
Funding
No grant is acknowledged in the PubMed record.
Abstract
To overcome the limitations of single-dimensional data and low efficiency in traditional cycloidal gear inspection, a comprehensive machine vision-based method was proposed. A high-precision vision platform was established, and a Sigmoid surface-based edge detection algorithm was employed for sub-pixel edge localization. Logarithmic transformation combined with light intensity compensation was applied to correct saturation-induced errors. The pixel equivalent and compensation coefficient were systematically calibrated using a dot-matrix plate and gauge blocks. A sub-pixel tooth profile model in the physical coordinate system was reconstructed through pixel equivalent calibration, dynamic light intensity compensation, and multi-coordinate transformation. Comparative tests against a coordinate measuring machine (CMM) verified that the point-to-point deviation between the two measurement systems was within 10 μm (maximum 11.62 μm). The inherent tooth profile deviation of the tested cycloidal gears, which reflects the machining quality of workpieces, ranged from 24 μm to 37 μm. Multiple repeated tests prove that the system achieves a repeat positioning accuracy of 0.8 μm. Based on the measurement characteristics, a hybrid analytical method integrating Cartesian and polar coordinate systems was developed, enabling the simultaneous evaluation of critical geometric tolerances, such as the diameters of the center hole and crankshaft hole. The full inspection cycle for cycloidal gears was reduced to 13 s, which demonstrates a substantial efficiency improvement over traditional methods.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.