ArticleInternational journal of retina and vitreous2026
The effect of syringe design and cannula dimensions on time-force curve in intravitreal injection across different drug viscosities: area under the curve and peak injection force.
Article in International journal of retina and vitreous, 2026. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
8 authors.
Funding
No grant is acknowledged in the PubMed record.
Abstract
backgroundNew intravitreal medications can offer longer treatment duration by using higher drug concentrations, which, in turn, increase viscosity. There is also a trend toward having smaller-gauge cannulas, which require a higher injection force. While the ophthalmologist cannot control viscosity, the choice of syringe may affect the force needed to administer the drug. This study compared two standard 1-ml syringes (BD Plastipak™ and Braun Injekt®-F) with a syringe featuring a reduced plunger diameter (Zero Residual™ 0·2 mL silicone oil-free syringe) for injecting a variety of fluids with viscosity that mimics commonly used intravitreal formulations.
methodsInjection force over time was measured for each combination of the three syringes, four fluids, and two cannulas (30 G and 33 G), and the results were compared using a two-way ANOVA, followed by Tukey’s post-hoc test. Plungers of the 1ml syringes had a diameter of approximately 4.70mm, while the smaller syringe had a plunger diameter of 2.48mm. Of the 1ml syringes, one was silicone oil lubricated (BD Plastipak™). The tested fluids were chosen to simulate bevacizumab (Balanced Salt Solution), pegcetacoplan (13.8 mg/0.1 ml of PEG-40,000), a high-viscosity solution (40 mg/0.1 ml of PEG-400), and a very high-viscosity solution (Tween 80 diluted with BSS).
resultsThe Zero Residual syringe required significantly lower injection forces, as quantified by both the area under the curve (AUC) and peak force. These effects became more pronounced when using smaller-diameter cannulas and increasingly viscous fluids. The BD Plastipak needed lower forces than the Braun Injekt-F.
conclusionsWhile silicone-oil lubrication reduced injection force, its effect was modest compared with that of plunger diameter, which was the primary determinant of the injection force required for a given viscosity and cannula diameter.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.