ArticleMaterials (Basel, Switzerland)2025
Thin Wall Milling at a Maximized Axial Depth of Cut.
Article in Materials (Basel, Switzerland), 2025. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 1 paper.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
1 citing paper in PubMed.
- Thin Wall Milling at a Maximized Axial Depth of Cut: An Analysis of Thermal and Mechanical Interactions.Materials (Basel, Switzerland) · 2025Article
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
1 author.
Funding
Abstract
The objective of the study was to determine the minimum thickness of a thin wall for milling at a maximized axial depth of cut, considering the effect of cutting speed on residual stress and post-machining distortion. Test samples were made of aluminum alloy 7050 T7451. The milling operation at a maximized axial depth of cut was performed during finishing. Response surface methodology was employed. Wall thickness and cutting speed were considered as two independent variables, while dependent variables were flatness deviation, wall thickness deviation, and residual stress. Flatness deviation and wall thickness deviation were used as the indicators of post-machining wall deformation and their measurements were made using a coordinate measuring machine. Residual stress was measured with an X-ray diffractometer. The obtained results showed that thin wall milling at a maximized axial depth of cut was feasible; nevertheless, for a wall thickness of
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.