ArticleMicromachines2025
Analysis of the Material Removal Process in Precision Milling of AZ91D Magnesium Alloy.
Article in Micromachines, 2025. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
1 author.
Funding
Abstract
The study investigated the material removal process during precision milling of AZ91D magnesium alloy. A high-speed camera enabling high-frequency image recording was used to observe the cutting zone. In effect, it was possible to observe the mechanism of the chip formation process at different stages of the cutting flutes performance. Experiments were conducted with different feeds per tooth in order to detect the occurrence of ploughing. Results showed that the both cutting flutes of the end mill did not perform in a uniform manner. Material was predominantly removed by first flute, as a result of which chips formed by this flute were much larger than those generated by the other flute. Nevertheless, the shearing process proceeded effectively even at low feed values. Results also showed that large burrs were formed when machining was conducted with low feed per tooth, which confirmed a significant contribution of plastic deformation to burrs formation. An increase in feed per tooth, however, made it possible to minimize the phenomenon of burrs formation.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.