Resistive Heater Element Based on a Conductive Line in AlN Ceramic Fabricated by Laser Processing.

The purpose of this work is to demonstrate that laser-induced conductive tracts in AlN ceramic can be applied for fabrication of an integrated resistive heating element. Nanosecond laser processing at a wavelength of 1064 nm of ceramic in vacuum is used for a formation of conductive areas. It is demonstrated that the applied laser fluence and the number of pulses influence strongly the electrical properties of the material in the irradiated zone. The resistance value of the produced tracks with a length of about 4 mm and width of about 1 mm may vary from 17 to about 2000 Ohms, depending on the processing conditions. The material in the processed zone is characterized by means of surface composition, morphology, and electric properties. It is found that the electrical conductivity of the formed structure is based on the ceramic decomposition and formation of aluminum layer. The analysis of the influence of the temperature on the electrical resistance value shows that the material's conductivity could be preserved after annealing, as in the present study it is confirmed up to 300 °C. The ability of the formed tracks to serve as a basis element of ceramic integrated resistive heater is studied by applying DC voltage. It is found that the fabricated element can be used with a high reliability to about 90 °C without special requirements for contact design and encapsulation. Operation at higher temperatures is also demonstrated as the maximal one achieved is about 150 °C at 10V. The performance of the heater is investigated and discussed as the operation range is defined. The proposed element can be a basis for a design of an integrated heater in ceramic with high stability and applications in everyday life and research.