Enhancement of Roll-to-Roll Gravure-Printed Cantilever Touch Sensors via a Transferring and Bonding Method.

Sang Hoon Lee, Jae Hak Shin, Sangyoon Lee

Abstract read

In one paragraph

Article in Sensors (Basel, Switzerland), 2025. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.

0numbers the graph read from it

0cells of the map it votes in

0citing papers in PubMed

–field-weighted citation impact

1 · What the graph read from it

What it found

Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.

The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.

2 · The registry

The trial behind it

Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.

Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.

3 · Its place in the literature

Who cites it

0 citing papers in PubMed.

No citing paper in PubMed yet.

4 · The record

Corrections and comments

PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.

5 · Who and what money

Authors and funding

3 authors.

Sang Hoon LeeDepartment of Chemical and Biomolecular Engineering, University of California, Irvine, Irvine, CA 92697, USA.ORCID 0009-0000-5828-7874

Jae Hak ShinDepartment of Mechanical Design and Production Engineering, Konkuk University, Seoul 05029, Republic of Korea.

Sangyoon LeeDepartment of Mechanical and Aerospace Engineering, Konkuk University, Seoul 05029, Republic of Korea.ORCID 0000-0002-7037-736X

Funding

National Research Foundation of Korea 2021R1A2C1008712

6 · The paper itself

Abstract

Sensor miniaturization offers significant advantages, including enhanced SoC integration efficiency, reduced cost, and lightweight design. While the roll-to-roll printed electronics fabrication process is advantageous for the mass production of sensors compared to the traditional MEMS technology, producing sensors that require air gap-based 3D structures remains challenging. This study proposes an integration of roll-to-roll gravure printing with a transferring and bonding method for touch sensor fabrication. Unlike previously reported methods for sacrificial layer removal, this approach prevents stiction issues, thus enabling sensor miniaturization and providing the flexibility to select materials that minimize sensitivity degradation during scaling. For the lower part of the sensor, Ag and BaSO

Indexed as

air gapcantilevercapacitive touch sensorgravure printingroll to rolltransferring and bonding method

Identifiers

PMID39943268

DOI10.3390/s25030629

PMCPMC11819942

What OpenQuestion holds

Textmetadata

LicenceCC BY

Read underepoch 390

Registered trials

None linked

Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.