Article3D printing and additive manufacturing2024
Fabrication of Piezoelectric Structures with High Porosity by Digital Light Processing.
Article in 3D printing and additive manufacturing, 2024. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
4 authors.
Funding
No grant is acknowledged in the PubMed record.
Abstract
Digital light processing is a recently developed solution to fabricate complex structured piezoelectric devices. To obtain a high-performance device, the slurry configuration, model slicing, and heat treatment methods during the printing should be carefully determined. In this article, 200 nm particle size barium titanate powders with an optimized solid content of 80% (mass fraction) were used to configure the slurry with higher printing efficiency. The slicing method with the printing direction perpendicular to the poling direction demonstrated higher piezoelectric performance. In addition, piezoelectric parts have a higher piezoelectric response and less deformation after sintering at 1450°C. After finding the above three important optimization parameters, a piezoelectric structure with high porosity was fabricated as an example to show that printed parts of 70% porosity still can keep a high piezoelectric response.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.