Numerical and Experimental Research of the Plastic Forming Process of Hastelloy X Alloy Sheets Using Elastomeric and Steel Tools.

The results of experimental and numerical studies of plastic forming of sheets made of the difficult-to-deform Hastelloy X, a nickel-based alloy with a thickness of 1 mm, using layered elastomeric punches and steel dies, are presented in this publication. The elastomeric punches were characterized by hardness in the range of 50-90 Shore A, while the dies were made of 90MnCrV8 steel with a hardness of over 60 HRC. The principle of operating the stamping die was based on the Guerin method. The finite-element-based numerical modeling of the forming process for various configurations of polyurethane inserts was also carried out. The results obtained from numerical modeling were confirmed by the results of experimental tests. The drawpieces obtained through sheet forming were subjected to geometry tests using optical 3D scanning. The results confirmed that in the case of forming difficult-to-deform Hastelloy X, Ni-based alloy sheets, the hardness of the polyurethane inserts significantly affected the geometric quality of the obtained drawpieces. Significant nonuniform sheet metal deformations were also found, which may pose a problem in the process of designing forming tools and the technology of the plastic forming of Hastelloy X, Ni-based alloy sheets.