Influence of Finishing Process Parameters of HDF Boards on Selected Properties of Coatings in Modern UV Lines and Their Relation to Energy Consumption.

Maciej Tokarczyk, Barbara Lis, Tomasz Krystofiak

Abstract read

In one paragraph

Article in Materials (Basel, Switzerland), 2024. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.

0numbers the graph read from it

0cells of the map it votes in

0citing papers in PubMed

–field-weighted citation impact

1 · What the graph read from it

What it found

Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.

The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.

2 · The registry

The trial behind it

Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.

Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.

3 · Its place in the literature

Who cites it

0 citing papers in PubMed.

No citing paper in PubMed yet.

4 · The record

Corrections and comments

PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.

5 · Who and what money

Authors and funding

3 authors.

Maciej TokarczykDepartment of Wood Science and Thermal Techniques, Faculty of Forestry and Wood Technology, Poznan University of Life Sciences, Wojska Polskiego 28, 60-627 Poznan, Poland.

Barbara LisDepartment of Wood Science and Thermal Techniques, Faculty of Forestry and Wood Technology, Poznan University of Life Sciences, Wojska Polskiego 28, 60-627 Poznan, Poland.

Tomasz KrystofiakDepartment of Wood Science and Thermal Techniques, Faculty of Forestry and Wood Technology, Poznan University of Life Sciences, Wojska Polskiego 28, 60-627 Poznan, Poland.ORCID 0000-0002-2060-0295

Funding

National Center for Research and Development (Poland) - Borne Furniture Company (Poland) POIR.01.01.01-00-1235/17

6 · The paper itself

Abstract

This study analyzes the influence of energy generated by emitters on the adhesive properties of varnish coatings in multilayer UV systems. The experimental material, in the form of a cell board finished with UV varnish products, was prepared on a prototype line under the conditions of Borne Furniture in Gorzów Wielkopolski. The roughness and wettability were measured using a OneAttension tensiometer integrated with a topographic module, taking into account the Wenzel coefficient. The adhesion of the examined systems was verified using the PositiTest AT-A automatic pull-off device. Energy consumption by the prototype production line was compared to the standard line, utilizing mercury emitters and mercury emitters with added gallium. Energy consumption was calculated for selected variants. The influence of the Wenzel coefficient on the wettability angle was observed. Significant differences between contact angles (CA and CAc) were noted for coatings formed with sealers (stages I and II). The largest discrepancies, reaching up to 30 degrees, were recorded at the lowest UVA and UVV doses of 26 mJ/cm

Indexed as

contact angleenergysurfacetopographyUV curing processUV lacquer systemWenzel coefficient

Identifiers

PMID39597217

DOI10.3390/ma17225393

PMCPMC11595935

What OpenQuestion holds

Textmetadata

LicenceCC BY

Read underepoch 390

Registered trials

None linked

Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.