Bonding Behavior and Quality of Pressureless Ag Sintering on (111)-Oriented Nanotwinned Cu Substrate in Ambient Air.

(111)-oriented nanotwinned Cu ((111)nt-Cu) has shown its high surface diffusion rate and better oxidation resistance over common polycrystalline Cu (C-Cu). The application of (111)nt-Cu as an interface metallization layer in Ag-sintered technology under the role of oxygen was investigated in this work, and its connecting behavior was further clarified by comparing it with C-Cu. As the sintering temperature decreasing from 300 to 200 °C, the shear strength on the (111)nt-Cu substrate was still greater than 55 MPa after sintering for 10 min. The fracture surface correspondingly changed from the interface of Ag/die to mixed fracture mode, involving the interface of the Ag/Cu substrate and Ag/die. The existence of copper oxide provided a tight connection between Ag and the (111)nt-Cu substrate at all of the studied temperatures. Although lots of small dispersed voids were seen at the interface between copper oxide and (111)nt-Cu at 300 °C, these impurity-induced voids would not necessarily be a failure position and could be improved by adjusting the sintering temperature and time; for example, 200 °C/10 min or heating to 300 °C, and then start cooling at the same time. The microstructure of Ag-Cu joint on (111)nt-Cu behaved better than that on C-Cu. The thinner copper oxide layer and the higher connection ratio of the interface between copper oxide and Ag were still found on the (111)nt-Cu connection's structure. The poor connection between copper oxide and Ag on C-Cu easily became the failure interface. By controlling the thickness of copper oxide and the content of impurity-induced voids, the use of (111)nt-Cu in advanced-packaging could be improved to a new level.