Fabrication and Characterization of Electrospun Ocimum sanctum and Curcumin-Loaded Nanofiber Membrane for the Management of Periodontal Disease: An In Vitro Study.

Background Periodontal disease is a chronic inflammatory condition that gradually deteriorates the supportive tissues of teeth, eventually leading to tooth loss. Mechanical debridement stands as the gold standard method for treating periodontitis. However, antimicrobial therapy is recommended for optimal results when used alongside mechanical debridement. Numerous studies have investigated local drug delivery as an adjunct to mechanical debridement of affected tooth surfaces. Ocimum sanctum exhibits anti-inflammatory, antioxidant, and antimicrobial properties. Similarly, curcumin, as documented in the literature, demonstrates a broad spectrum of anti-inflammatory and antimicrobial effects. Electrospinning has demonstrated itself to be a highly effective method for fabricating drug-loaded fibers. Electrospun nanofibers containing Ocimum sanctum and curcumin are expected to exhibit greater efficacy due to their increased surface area, facilitating the dispersion of larger quantities of drugs, and their ability to control drug release when employed as a local drug delivery system. This study aims to fabricate and characterize the properties of nanofiber membranes loaded with Ocimum sanctum and curcumin using the electrospinning technique. Methods About 50 mg each of Ocimum sanctum and curcumin were blended with 15% polyvinyl alcohol and 2% chitosan polymer in a 4:1 ratio and left to stir overnight. A 10 mL syringe was filled with this solution, and an 18 G blunt-end needle charged at 15.9 kV was used for extrusion. Continuous fibers were collected onto a collector plate positioned 12 cm from the center of the needle tip, at a flow rate of 0.005 mL/min. The morphology of the fabricated membrane was assessed through scanning electron microscopy (SEM), the strength of the material was assessed through tensile strength analysis using INSTRON, an Electropuls E3000 Universal Testing Machine (INSTRON, Norwood, MA), and the drug release pattern was analyzed using Jasco V-730 UV-visible spectrophotometer (Jasco, Easton, MD). Results The morphology of this nanofiber showed a random distribution of fibers with no bead formation. The average diameter of the membrane was 383±102 nm, and the tensile strength of this material was 1.87 MPa. The drug release pattern showed an initial burst release of Ocimum sanctum, followed by a controlled release in subsequent hours. However, curcumin showed very little drug release because of its solubility. Conclusion In summary, the Ocimum sanctum and curcumin-loaded nanofibers exhibited robust tensile strength, a controlled drug release profile, and uniform drug distribution within the nanofiber membrane. Consequently, it can be concluded that curcumin nanofibers and electrospun Ocimum sanctum serve as valuable agents for local drug delivery in the treatment of periodontitis.