Metallic Lateralized-Offset Glenoid Reverse Shoulder Arthroplasty.

Background: Metallic lateralized-offset glenoid reverse shoulder arthroplasty (RSA) for cuff tear arthropathy combines the use of a metallic augmented baseplate with a metaphyseally oriented short stem design that can be applied at a 135° or 145° neck-shaft angle, leading to additional lateralization on the humeral side. Lateralization of the center of rotation decreases the risk of inferior scapular notching and improves external rotation, deltoid wrapping, residual rotator cuff tensioning, and prosthetic stability Description: This procedure is performed via a deltopectoral approach with the patient in the beach-chair position under general anesthesia combined with a regional interscalene nerve block. Subscapularis tenotomy and capsular release are performed, the humeral head is dislocated, and any osteophytes are removed. An intramedullary cutting guide is placed for correct humeral resection. The osteotomy of the humeral head is performed in the anatomical neck with an inclination of 135° and a retroversion of 20° to 40°, depending on the anatomical retroversion. The glenoid is prepared as usual. The lateralized, augmented baseplate is assembled with the central screw and the baseplate-wedge-screw complex is placed by inserting the screw into the central screw hole. Four peripheral screws are utilized for definitive fixation. An eccentric glenosphere with inferior overhang is implanted. The humerus is dislocated, and the metaphysis is prepared. Long compactors are utilized for proper stem alignment, and an asymmetric trial insert is positioned before the humerus is reduced. Stability and range of motion are assessed. The definitive short stem is inserted and the asymmetric polyethylene is impacted, resulting in a neck-shaft angle of 145°. Following reduction, subscapularis repair and wound closure are performed. Alternatives: BIO-RSA is the main alternative to MIO-RSA. Boileau et al. Rationale: BIO-RSA has been proven to achieve excellent functional outcomes Expected Outcomes: A recent study evaluated the clinical and radiographic outcomes of metallic humeral and glenoid lateralized implants. A total of 42 patients underwent primary RSA. Patients were documented prospectively and underwent follow-up visits at 1 and 2 years postoperatively. That study demonstrated that bipolar metallic lateralized RSA achieves excellent clinical results in terms of shoulder function, pain relief, muscle strength, and patient-reported subjective assessment, without instability or radiographic signs of scapular notching Important Tips: When performing subscapularis tenotomy, leave an adequate stump to allow end-to-end repair.Tenotomize the superior part of the subscapularis tendon in an L-shape, sparing the portion below the circumflex vessels.As glenoid exposure is critical, perform a 270° capsulotomy.Continuously check the orientation of the baseplate relative to the prepared hole and reamed surface to ensure accurate implantation of the full wedge baseplate to achieve a proper fit.Aim for 70% to 80% seating of the baseplate onto the prepared glenoid surface. Avoid overtightening or excessive advancement of the baseplate into the subchondral bone. Gaps between the baseplate and glenoid surface should also be avoided.In order to avoid varus or valgus malpositioning of the final implant, obtain proper diaphyseal alignment by following "the three big Ls": large, lateral, and long. Use a large metaphyseal component to fill the metaphysis. Place the guide pin for the reaming of the metaphysis slightly laterally into the resected surface of the humerus. Use long compactors for diaphyseal alignment to avoid varus or valgus malpositioning of the final implant.Use an intramedullary cutting guide for correct humeral resection.Utilize the correct liner in order to obtain proper tensioning and avoid instability. Acronyms and Abbreviations: K wire = Kirschner wireROM = range of motion.