Using 5TE Sensors for Monitoring Moisture Conditions in Green Parks.

The ground surface and subsurface of green parks in arid and desert areas may be subjected to desiccation as a result of weather and hot temperatures. It is not wise to wait until plants are turning pale and yellow before watering is resumed. Given the scarcity of water in typical desert zones, we recommend full control of irrigation water. This study presents a method of recycling irrigation water using 5TE sensors, employing time-domain reflectometry (TDR) technology. A trial test section was constructed along the coast of the eastern province of Saudi Arabia. Water recycling involves using clay-sand liners placed below the top agricultural soils to intercept excess water and direct it towards a collection tank, and then it is pumped out to a major water supply tank. The main properties of soils and clay-sand liners normally taken into account include moisture content, density, and hydraulic conductivity. An assessment of geotechnical properties of clay-sand mixtures containing 20% clay content was conducted. The profiles of moisture and temperature changes were monitored using 5TE sensors and data loggers. The 5TE sensors provided continuous measurements at varying temperatures and watering cycles. Twenty-nine watering cycles were conducted over a six-month period. An additional section was considered with a liner consisting of the same clay but enhanced with bentonite as one-third of the clay content. The volumetric water content was found to vary from 0.150 to 0.565 following changing weather and direct watering cycles. The results indicated that the use of a TDR instrumentation is a cost-effective and time-saving technique to construct a system for saving irrigation water.