Effect of different ulnar osteotomies on loading of the distal radioulnar joint: a finite element analysis.

backgroundUlnar impingement syndrome is a prevalent source of ulnar carpal pain; however, there is ongoing debate regarding the specific location of shortening, the method of osteotomy, the extent of shortening, and the resulting biomechanical alterations.

methodTo investigate the biomechanical changes in the distal radioulnar joint (DRUJ) resulting from different osteotomy methods, a cadaveric specimen was dissected, and the presence of a stable DRUJ structure was confirmed. Subsequently, three-dimensional data of the specimen were obtained using a CT scan, and finite element analysis was conducted after additional processing.

resultsThe DRUJ stress did not change significantly at the metaphyseal osteotomy of 2-3 mm but increased significantly when the osteotomy length reached 5 mm. When the osteotomy was performed at the diaphysis, the DRUJ stress increased with the osteotomy length, and the increase was greater than that of metaphyseal osteotomy. Stress on the DRUJ significantly increases when the position is changed to pronation dorsi-extension. Similarly, the increase in stress in diaphyseal osteotomy was greater than that in metaphyseal osteotomy. When the model was subjected to a longitudinal load of 100 N, neither osteotomy showed a significant change in DRUJ stress at the neutral position. However, the 100 N load significantly increased stress on the DRUJ when the position was changed to pronation dorsi-extension, and the diaphyseal osteotomy significantly increased stress on the DRUJ.

conclusionsFor patients with distal oblique bundle, metaphyseal osteotomy result in a lower increase in intra-articular pressure in the DRUJ compared to diaphyseal osteotomy. However, it is crucial to note that regardless of the specific type of osteotomy employed, it is advisable to avoid a shortening length exceeding 5 mm.