Maximum in-vivo joint contact forces double during active compared to assisted motion in the glenohumeral joint and decline long-term due to rotator cuff pathologies.

Rehabilitation programs advocate early passive and assisted motion after rotator cuff repair to induce healing und maintaining range of motion while avoiding excessive strain on the repaired tendons. In-vivo glenohumeral joint contact forces reflect the compressive forces generated by the rotator muscles. In the present study, maximum in-vivo joint contact forces (FresMax) were determined to compare active and assisted execution of a single movement and the long-term development of joint compression forces. FresMax were measured in six patients who received instrumented, telemetric modified anatomical hemi endoprostheses of the shoulder joint between 2006 and 2008. Data were gathered 23 months postoperatively (2006-2010), were analysed and compared with measurements 133 months postoperatively. Additional imaging was obtained as x-rays and ultrasound examination. Data analysis was conducted by synchronizing video tapes and measured force curves. New imaging showed a rupture of the M. supraspinatus and progressive joint degeneration. FresMax nearly doubled during active compared to assisted execution of each of the four chosen movements. Over the course of 133 months post-surgery, the studied movements showed a decrease of active compression force, probably due to a ruptured supraspinatus, resulting in a lower active/assisted ratio. A long term follow up after eleven years, eight out of ten measured movements showed a decrease of FresMax. These results support current rehabilitation protocols recommending early passive and assisted motion to limit activation of the rotator muscles generating compressive forces. Following degeneration of the rotator cuff, active joint contact forces decrease over time.Level of evidence: III.