organo acid-activated clays for water treatment as removal agent of Eosin-Y: Properties, regeneration, and single batch design absorber.

Organoclays have been proposed as efficient removal agents for colored wastewater treatment. In this study, organo-acid-activated clays were investigated for their ability to remove eosin Y dye molecules. Firstly, the clay was acid activated using sulfuric solution at 90 °C for overnight. Secondly, the resulting materials were treated by hexadecyltetramethylammonium bromide solutions to obtain organo-acid-activated clays. Several techniques were used, such as X-ray diffraction, carbon hydrogen nitrogen analysis, silicon-29 and carbon-13 solid-state nuclear magnetic resonance, and nitrogen adsorption isotherms. The cation exchange capacity values were reduced and the specific surface area values increased from 80.1 m2/g to 183.2 m2/g during the acid activation process. The resulting organo-acid-activated clays had a similar expansion of interlayer spacing of 3.90 nm with less intercalated hexadecyltetramethylammonium surfactants, ranging from 0.80 mmol/g to 1.22 mmol/g; 13C solid NMR indicated that the intercalated surfactants exhibited different degree of conformation. Many factors, including the solid dose, solution pH, amount of intercalated surfactants, and starting eosin-Y concentrations, were studied in relation to the removal capabilities of organo acid-activated clays. Based on the Langmuir model, the removal capacity of the organo acid-activated clays ranged from a minimum of 43.5 mg/g to a maximum of 79.3 mg/g, dependent on the surfactant quantities and acid activation degree. , and the pH. The removal percentage of eosin-Y was increased from 50.5 % to 80.8 % by treating the organo acid-activated clay with HCl solution before the removal procedure. Regeneration and reuse of two selected organo acid-activated clays were carried out for seven successive cycles, and a reduction in the initial efficiency was in the range of 26.4 %-30.1 %. However, for organoclay (without acid activation), approximately 52.1 % efficiency was maintained. Using the Langmuir model and mass balance equations, a single-stage adsorber design was suggested for different dye volumes at a constant starting concentration.