Analysis of the Effect of an Open Hole on the Buckling of a Compressed Composite Plate.

This paper investigates the effect of an open hole on the stability of a compressed laminated composite plate. The study was carried out in two ways: using experimental tests and numerical analysis. As a result of the experiment, the buckling form and path of the plate were recorded. The form of buckling was determined using the ARAMIS non-contact measurement system. The critical load value was determined from the working path using the approximation method. The experimental results were verified by numerical analysis based on the finite element method. FEM investigations were carried out in terms of a linear eigenproblem analysis. This allowed the bifurcation load and the corresponding buckling form of the numerical model of the plate to be determined. Investigating the effect of the hole in the compressed plate at a critical state showed high agreement between the proposed test methods. No clear effect of the hole size on the buckling of the plate was observed. In contrast, a clear effect of the hole on the critical load value was determined. The maximum decrease in the critical load value was 14%. The same decrease was observed for the stiffness of the post-critical characteristics. It was shown that the [45|-45|90|0]s composite plate had more than three times lower strength compared to [0|-45|45|90]s and [0|90|0|90]s. The novelty of this article is the development of a research methodology based on new interdisciplinary research methods for describing the influence of the central hole on the stability of compressed composite plates. The ABAQUS system was used for the numerical analysis.