Evaluation of the quality and safety of commercial complementary foods: Implications for nutrient adequacy and conformance with national and international standards.

Optimal nutrition in early childhood increases growth and development while preventing morbidity and mortality in later life. This study focused on the quality and safety of 32 commercially produced complementary foods collected from supermarkets in Addis Ababa, Ethiopia. The proximate composition (moisture, protein, fat, crude fibre, and ash); and the mineral profile (calcium, iron, zinc, manganese, and magnesium) were determined using the AOAC method. The determination of antinutritional factors (Condensed tannin and oxalate) was done using a UV spectrophotometer. A rapid visco analyzer was used to measure the rheological property. The microbial load of commercially produced complimentary foods was identified using aerobic colony counts for mold and yeast. Labeling practice was evaluated using the WHO and Ethiopian standard tools. The results of proximate compositions were: protein (0.92-18.16 g/100g), fat (0.63-6.44 g/100g), crude fiber (1.04-13.2 g/100g), energy (410-337 kcal/100g), moisture (0.03-17 g/100g), and ash (0.60-4.67 g/100g). The protein and fat content of all the products is below international standards. Only three products met the standards for energy. Moisture and ash contents partially met the requirement, while all of the carbohydrate contents of the products fell under the specified standard. The lowest and highest mineral contents of the products were: Fe (1.38 to 15.10 mg/100g), Zn (0.64 to 6.78 mg/100g), Ca (30.55 to 364.45 mg/100g), Mg (1.2 to 34.2 mg/100g), and Mn (0.80 to 32 mg/100g). Based on these, 21.5% of the foods met the Fe standard, and 31.5% didn't meet the Zn standard. The Ca and Mg of all the products met the requirement. Except for one product, all met standards. The highest and lowest results for the tannin and oxalate content of the products were 49.20 to 90.09 mg/100g and 0.47 to 30.10 mg/100g, respectively and this shows that the products are below the permissible range for tannin and oxalate. The counts of yeast and mold were 0.00-2.95 log10 cfu/g and 0.00-2.91 log10 cfu/g, respectively. Only one product fell below the standard for yeast count, and none of the products showed a mold count that exceeded the standard. The final viscosity was 63.5-3476 RVU, and only 31.25% of the samples fell under the permissible peak viscosity range, of 83-250 RVU. Thus, regular monitoring of the raw material and processing trends and the inclusion of animal sources in the raw material are suggested for having well-enriched complementary foods. Regulatory bodies should also conduct frequent market surveillance to safeguard the health of the consumer.