ArticleACS omega2023
An Investigation on the Acetone and Ethanol Vapor-Sensing Behavior of Sol-Gel Electrospun ZnO Nanofibers Using an Indigenous Setup.
Article in ACS omega, 2023. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 1 paper.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
1 citing paper in PubMed.
- Chemoresistive Gas Sensors Based on Electrospun 1D Nanostructures: Synergizing Morphology and Performance Optimization.Sensors (Basel, Switzerland) · 2024Review
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
6 authors.
Funding
No grant is acknowledged in the PubMed record.
Abstract
The calibration is essential for accuracy, repeatability, and continuous trouble-free operation of gas sensors with safety. Most gas sensors are fabricated using metal oxide nanomaterials in different structures such as films, coating, or nanofibers. Therefore, a device in the sensor manufacturing industry is necessary to test, calibrate, and optimize metal oxide structures. In this point of view, a simple device is developed to test and estimate the sensing response, response time, and recovery time of nanostructures. The sol-gel method was used to produce nanofibers through electrospinning. An average fiber diameter of 245 nm was obtained after pyrolysis at 600 °C. The structure and composition of ZnO nanofibers are confirmed by X-ray diffraction, scanning electron microscopy, and Brunauer-Emmett-Teller. The trials were taken using ZnO nanofibers in the presence of acetone and ethanol vapor, and the results were reported. High response (31.74), rapid response (40 s), and recovery (30 s) times have been achieved for ethanol gas to 50 ppm concentration test gas at an optimal temperature of 260 °C. The results obtained from the trials are compared with the literature results, which are in line with the values presented by the various researchers. Due to the low cost, easy maintenance, and accuracy, this device is recommended in metal oxide sensor development industries and laboratories.
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.