Study on Cavitation, Warpage Deformation, and Moisture Diffusion of Sop-8 Devices during Molding Process.

Plastic packaging has shown its advantages over ceramic packaging and metal packaging in lightweight, thin, and high-density electronic devices. In this paper, the reliability and moisture diffusion of Sop-8 (Small Out-Line Package-8) plastic packaging devices are studied, and we put forward a set of complete optimization methods. Firstly, we propose to improve the reliability of plastic packaging devices by reducing the amount of cavitation and warpage deformation. Structural and process factors were investigated in the injection molding process. An orthogonal experiment design was used to create 25 groups of simulation experiments, and Moldflow software was used to simulate the flow mode analysis. Then, the simulation results are subjected to range analysis and comprehensive weighted score analysis. Finally, different optimization methods are proposed according to different production conditions, and each optimization method can reduce cavitation or warpage by more than 9%. The moisture diffusion of the Sop-8 plastic packing devices was also investigated at the same time. It was determined that the contact surface between the lead frame and the plastic packaging material was more likely to exhibit delamination under the condition of MSL2 moisture diffusion because the humidity gradient was easily produced at the crucial points of different materials. The diffusion of moisture is related to the type of plastic packaging material and the diffusion path.