Mass Reduction Techniques for Short Backfire Antennas: Additive Manufacturing and Structural Perforations.

This paper presents novel approaches for reducing the mass of the classical short backfire (SBF) antenna by using additive manufacturing and structural perforations. We first investigated techniques to create a 3D-printed structure with a conductive coating material. This approach resulted in a significant mass reduction (70%) compared with the conventional metallic structure. We performed parametric simulation studies to investigate the effects of the manufacturing process and showed that there was practically no difference in the performance. The largest source of error was the surface roughness and the conductivity of the metal paint. In a second design, we created perforations in the structure to further reduce the mass. We performed parametric studies to optimize mass reduction and to characterize the effects of the perforations and the surface roughness introduced during the 3D-printing process on the antenna. Antenna prototypes were fabricated and tested. The masses of the perforated 3D printed antenna were approximately 30% and 20% of the original aluminum design, respectively (70% and 80% reductions in mass, respectively). The good agreement among the original design, simulation, and measurements demonstrated the effectiveness of the approach.