ArticlePolymers2023
Three-Dimensional Printing of Shape Memory Liquid Crystalline Thermoplastic Elastomeric Composites Using Fused Filament Fabrication.
Article in Polymers, 2023. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
5 authors.
Funding
No grant is acknowledged in the PubMed record.
Abstract
Liquid crystalline elastomers (LCEs) are stimuli-responsive materials utilised in shape memory applications. The processability of these materials via advanced manufacturing is being paid increasing attention to advance their volume production on an industrial scale. Fused filament fabrication (FFF) is an extrusion-based additive manufacturing (AM) technique that offers the potential to address this. The critical challenge, however, is the rheological characteristics of LCEs that need to be tuned to achieve a facile processability through the extrusion-based method. In this work, new filaments of liquid crystalline thermoplastic elastomer (LCTPE) and its composites with lignin were made by the ternary system of LCE, thermoplastic polyurethane (TPU), and lignin. The results showed that TPU improves the melt flow index of the LCTPE system to approximately 10.01 g/10 min, while adding lignin further enhances the value of this index for the composites up to 21.82 g/10 min. The microstructural analysis indicated that the effective distribution of lignin and reduced domain size of the LCEs in the ternary blend contribute to the enhanced flowability of this filament through 3D printing. Samples of 3D-printed LCTPE and LCTPE/lignin composites maintained their shape memory characteristics via thermomechanical activation. Full shape recovery of the new LCTPE matrix and its composites with lignin was achieved in 39 s and 32 s at 130 °C, followed by 28 s and 24 s at 160 °C, respectively. The successful fabrication of LCTPE and LCTPE/lignin composite samples through 3D printing demonstrates a potential procedure for processing these shape memory materials using the FFF technique, and lignin offers a sustainable and cost-effective material solution that enhances the properties of this composite material.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.