ArticlePolymers2023
A Printing Strategy for Embedding Conductor Paths into FFF Printed Parts.
Article in Polymers, 2023. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
4 authors.
Funding
Abstract
A novel approach to manufacture components with integrated conductor paths involves embedding and sintering an isotropic conductive adhesive (ICA) during fused filament fabrication (FFF). However, the molten plastic is deposited directly onto the adhesive path which causes an inhomogeneous displacement of the uncured ICA. This paper presents a 3D printing strategy to achieve a homogeneous cross-section of the conductor path. The approach involves embedding the ICA into a printed groove and sealing it with a wide extruded plastic strand. Three parameter studies are conducted to obtain a consistent cavity for uniform formation of the ICA path. Specimens made of polylactic acid (PLA) with embedded ICA paths are printed and evaluated. The optimal parameters include a groove printed with a layer height of 0.1 mm, depth of 0.4 mm, and sealed with a PLA strand of 700 µm diameter. This resulted in a conductor path with a homogeneous cross-section, measuring 660 µm ± 22 µm in width (relative standard deviation: 3.3%) and a cross-sectional area of 0.108 mm
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.