Evidence map›Paper›PMID 37481682›Full record

ArticleScientific reports2023

Circular polarized 3D-printed cylindrical DRA using parasitic dielectric helix.

Sebastian Diaz, Marcos Diaz, Eva Rajo-Iglesias, Francisco Pizarro

Abstract read
In one paragraph

Article in Scientific reports, 2023. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.

0numbers the graph read from it
0cells of the map it votes in
0citing papers in PubMed
–field-weighted citation impact
1 · What the graph read from it

What it found

Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.

The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.

2 · The registry

The trial behind it

Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.

Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.

3 · Its place in the literature

Who cites it

0 citing papers in PubMed.

No citing paper in PubMed yet.

4 · The record

Corrections and comments

PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.

5 · Who and what money

Authors and funding

4 authors.

Sebastian DiazEscuela de Ingeniería Eléctrica, Pontificia Universidad Católica de Valparaíso, 2362804, Valparaiso, Chile.
Marcos DiazSpace and Planetary Exploration Laboratory (SPEL), Electrical Engineering Department, Faculty of Physical and Mathematical Sciences, University of Chile, 8370448, Santiago, Chile.
Eva Rajo-IglesiasDepartment of Signal Theory and Communication, University Carlos III of Madrid, 28911, Madrid, Spain.
Francisco PizarroEscuela de Ingeniería Eléctrica, Pontificia Universidad Católica de Valparaíso, 2362804, Valparaiso, Chile. francisco.pizarro.t@pucv.cl.

Funding

Agencia Nacional de Investigación y Desarrollo FOVI210008Ministerio de Ciencia e Innovación PID2019-107688RB-C21
6 · The paper itself

Abstract

This article presents a 3D-printed cylindrical dielectric resonator antenna operating at 5.8 GHz that achieves circular polarization by integrating a fully dielectric parasitic helix with a higher permittivity than the cylindrical resonator. The antenna polarization can be right-handed or left-handed depending on the turning sense of the helix. An extensive parametric study was done for the helix design to evaluate the effects of the dimensions and dielectric constant of the helix over the matching and axial ratio of the antenna. The manufacturing is made using low-loss dielectric filaments and a low-cost 3D printer. Simulation and measurement results show that both antennas are well-matched and operate with the corresponding circular polarization, with an axial ratio bandwidth compatible with UAV applications.

Identifiers

PMID37481682
PMCPMC10363132

What OpenQuestion holds

Textmetadata
LicenceCC BY
Read underepoch 390

Registered trials

None linked

Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.