ArticleMicromachines2023
An Online Measurement and Calibration Method for a Radio Telescope Sub-Reflector Support Structure Using Fiber Bragg Grating.
Article in Micromachines, 2023. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 2 papers.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
2 citing papers in PubMed.
- Real-Time Reconstruction of the Temperature Field of NSRT's Back-Up Structure Based on Improved RIME-XGBoost.Sensors (Basel, Switzerland) · 2025Article
- The Enhanced Measurement Method Based on Fiber Bragg Grating Sensor for Structural Health Monitoring.Micromachines · 2025Article
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
2 authors.
Funding
Abstract
The position and altitude of a sub-reflector have an important influence on the pointing accuracy of a radio telescope. With the increase of the antenna aperture, the stiffness of the support structure for the sub-reflector decreases. This causes deformation of the support structure when environmental loads, such as gravity, temperature, and wind load, are applied to the sub-reflector, which will seriously influence antenna pointing accuracy. This paper proposes an online measurement and calibration method for assessing the deformation of the sub-reflector support structure based on the Fiber Bragg Grating (FBG) sensors. Firstly, a reconstruction model between the strain measurements and the deformation displacements of a sub-reflector support structure is established based on the inverse finite element method (iFEM). In addition, a temperature-compensating device with an FBG sensor is designed to eliminate the effects of temperature variations on strain measurements. Considering the lack of the trained original correction, a non-uniform rational B spline (NURBS) curve is built to extend the sample data set. Next, a self-structuring fuzzy network (SSFN) is designed for calibrating the reconstruction model, which can further improve the displacement reconstruction accuracy of the support structure. Finally, a full-day experiment was carried out using a sub-reflector support model to verify the effectiveness of the proposed method.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.