ArticleACS applied materials & interfaces2023
Rapid Printing of Pseudo-3D Printed SnSe Thermoelectric Generators Utilizing an Inorganic Binder.
Article in ACS applied materials & interfaces, 2023. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 2 papers.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
2 citing papers in PubMed.
- Ink-Printed Thermoelectric Materials and Devices: Material Preparation, Fabrication Techniques, and Applications.Small science · 2026Review
- Extrusion-printed LaNature communications · 2026Article
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
6 authors.
Funding
No grant is acknowledged in the PubMed record.
Abstract
There has been much interest in tin selenide (SnSe) in the thermoelectric community since the discovery of the record zT in the material in 2014. Manufacturing techniques used to produce SnSe are largely energy-intensive (e.g., spark plasma sintering); however, recently, in previous work, SnSe has been shown to be produced via a low embodied energy printing technique, resulting in 3D samples with high zT values (up to 1.7). Due to the additive manufacturing technique, the manufacturing time required was substantial. In this work, 3D samples were printed using the inorganic binder sodium metasilicate and reusable molds. This facilitated a single-step printing process that substantially reduced the manufacturing time. The printed samples were thermally stable through multiple thermal cycles, and a peak zT of 0.751 at 823 K was observed with the optimum binder concentration. A proof-of-concept thermoelectric generator produced the highest power output of any reported printed Se-based TEG to date.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.