The Effects of rGO Content and Drying Method on the Textural, Mechanical, and Thermal Properties of rGO/Polymer Composites.

Composite hydrogels samples consisting of poly(methyl methacrylate/butyl acrylate/2-hydroxyethylmethacrylate) (poly-OH) and up to 60% reduced graphene oxide (rGO) containing rGO were synthesized. The method of coupled thermally induced self-assembly of graphene oxide (GO) platelets within a polymer matrix and in situ chemical reduction of GO was applied. The synthesized hydrogels were dried using the ambient pressure drying (APD) and freeze-drying (FD) methods. The effects of the weight fraction of rGO in the composites and the drying method on the textural, morphological, thermal, and rheological properties were examined for the dried samples. The obtained results indicate that APD leads to the formation of non-porous xerogels (X) of high bulk density (D), while FD results in the formation of highly porous aerogels (A) with low D. An increase in the weight fraction of rGO in the composite xerogels leads to an increase in D, specific surface area (SA), pore volume (Vp), average pore diameter (dp), and porosity (P). With an increase in the weight fraction of rGO in A-composites, the D values increase while the values of SP, Vp, dp, and P decrease. Thermo-degradation (TD) of both X and A composites takes place through three distinct steps: dehydration, decomposition of residual oxygen functional group, and polymer chain degradation. The thermal stabilities (TS) of the X-composites and X-rGO are higher than those of the A-composites and A-rGO. The values of the storage modulus (E') and the loss modulus (E") of the A-composites increase with the increase in their weight fraction of rGO.