Effects of Hygrothermal and Salt Mist Ageing on the Properties of Epoxy Resins and Their Composites.

Epoxy and epoxide composites have a wide range of outdoor applications wherein they are affected by ageing. In this study, epoxy casting plates and epoxy-based composite rods for use in overhead conductors were prepared. A concurrent investigation concerning the ageing of epoxy resins and their carbon fibre composites was carried out via artificially accelerated experiments under hygrothermal and salt mist conditions. The moisture penetration along the depth, water absorption, appearance, hardness, density of the epoxy resins, and variation patterns of the impact strength and tensile strength of the epoxy-based composites were investigated. The ageing mechanisms were explored using Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM). Both ageing modes had essentially similar influences on the properties of the resins and their composites; moreover, they did not significantly affect the chemical structure and microstructure of the epoxy resin, with the physical adsorption of water primarily observed during the ageing process. The moisture absorption behaviour of the epoxy obeyed Fick's law. Although the water penetration rate in the salt mist ageing mode was slightly higher than that in the hygrothermal ageing mode during the early ageing stage, it was essentially the same during the later stage. The final moisture absorption rate at saturation was approximately 1.1% under both modes. The flexural strengths and impact strengths of the composites in both ageing modes followed a similar trend. They decreased gradually with the ageing time and then stabilized at almost the same value. The flexural strength was reduced from 803 MPa to 760 MPa and the impact strength from 383 J/m