Large Glenoid Defects Treated by Multiple Bioresorbable Pinning-Assisted Bone-Grafting in Reverse Shoulder Arthroplasty.

Large glenoid defects pose problems in reverse shoulder arthroplasty (RSA) Description: This procedure is performed with the patient under general anesthesia and in the beach-chair position, via a deltopectoral approach. After placing the structural graft, 5 to 10 provisional 1.5-mm Kirschner wires are inserted through the graft up the medal cortical bone of the scapula. The Kirschner wires are subsequently replaced with bioresorbable (BR) pins (1.5-mm Fixsorb Pin; TEIJIN). If more wires are needed, another set of 4 to 5 RB pins is inserted to gain initial stability. After placing the graft, the glenoid component is implanted as usual. Alternatives: Traditionally, 1 or 2 screws are inserted in the periphery of the graft to obtain stability. The screws either must be inserted at an angle that does not impede placement of the implant Rationale: In addition to facilitating initial graft stability, this procedure promotes graft incorporation. Typically, when performing this procedure, a total of 15 to 20 temporary Kirschner wires are placed in sets, with 5 to 7 wires per set. Of these, the most stable wires, usually 8 to 10 in total, are replaced by BR pins. The resultant bone holes, whether filled or unfilled with the BR pins, may promote neovascularization and osteoinduction, enabling long-lasting remodeling of and improved incorporation of the bone graft. Expected Outcomes: A prior study compared the use of MBP versus angulated bony-increased offset (BIO) graft, assessing graft incorporation according to the size of the remaining graft on axial radiographs, with full incorporation defined as >75% of the original graft size Important Tips: Expose all 4 quadrants of the glenoid in cases of type-2 deformity. Accurate orientation of the MBP is important.Expose the upper and lower 2 quadrants of the glenoid in cases of type-3 deformity. The bases of the scapular spine and axillary border serve as a graft scaffold.Preserve circumferential soft tissues in cases of type-3 deformity because these tissues will serve to contain cancellous bone graft.Keep the Kirschner wire that extends the most medially (reaching the most medial cortical bone of the scapula) as a future guidewire for drilling of the central peg hole. Acronyms and Abbreviations: RSA = reverse shoulder arthroplastyMBP = multiple bioresorbable pinningBIO = bony-increased offsetBR = bioresorbableTSA = total shoulder arthroplastyCT = computed tomographyK-wire = Kirschner wireROM = range of motionP.O. = postoperative.