ArticlePolymers2023
Dynamic Response and Deformative Mechanism of the Shape Memory Polymer Filled with Low-Melting-Point Alloy under Different Dynamic Loads.
Article in Polymers, 2023. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
3 authors.
Funding
Abstract
Low-melting-point alloy (LMPA) was used as an additive to prepare epoxy-resin-based shape memory polymer composites (LMPA/EP SMP), and dynamic mechanical analyzer (DMA) tests were performed to demonstrate the shape memory effect, storage modulus, and stiffness of the composites under different load cases. The composites exhibited an excellent shape recovery ratio and shape fixity ratio, and a typical turning point was observed in the storage modulus curves, which was attributed to the melting of the LMPA. In order to investigate the dynamic deformation mechanism at high strain rates, split Hopkinson pressure bar (SHPB) experiments were performed to study the influence of the strain rate and plastic work on the dynamic mechanical response of LMPA/EP composites. The results showed that there was a saturated tendency for the flow stress with increasing strain rate, and the composites exhibited a typical brittle failure mode at high strain rate. Moreover, an obvious melting phenomenon of the LMPA was observed by SEM tests, which was due to the heat generated by the plastic work at high strain rate. The fundamental of the paper provided an effective approach to modulate the stiffness and evaluate the characteristics of SMP composites.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.