Evidence map›Paper›PMID 36677260›Full record

ArticleMicromachines2023

An Investigation into the Effects of Electric Field Uniformity on Electrospun TPU Fiber Nano-Scale Morphology.

Aaron Morehouse, Kelton C Ireland, Gobinda C Saha

Abstract read
In one paragraph

Article in Micromachines, 2023. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.

0numbers the graph read from it
0cells of the map it votes in
0citing papers in PubMed
–field-weighted citation impact
1 · What the graph read from it

What it found

Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.

The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.

2 · The registry

The trial behind it

Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.

Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.

3 · Its place in the literature

Who cites it

0 citing papers in PubMed.

No citing paper in PubMed yet.

4 · The record

Corrections and comments

PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.

5 · Who and what money

Authors and funding

3 authors.

Aaron MorehouseNanocomposites and Mechanics Laboratory (NCM Lab), University of New Brunswick, Fredericton, NB E3B 5A3, Canada.
Kelton C IrelandNanocomposites and Mechanics Laboratory (NCM Lab), University of New Brunswick, Fredericton, NB E3B 5A3, Canada.
Gobinda C SahaNanocomposites and Mechanics Laboratory (NCM Lab), University of New Brunswick, Fredericton, NB E3B 5A3, Canada.ORCID 0000-0002-4591-7221

Funding

Natural Sciences and Engineering Research Council ALLRP 555163-20Natural Sciences and Engineering Research Council RGPIN-2018-04440
6 · The paper itself

Abstract

ANSYS Maxwell was used to replicate the conditions of two potential electrospinning configurations: a needle-plate and a parallel-plate configuration. Simulations showed that the electric field generated within the parallel-plate configuration was much more uniform than that within the needle-plate configuration. Both configurations were assembled and used electrospin fibers at three different spinning distances (10 cm, 12 cm, and 15 cm), at a consistent electric field strength of 1.7 kV/cm. Scanning electron microscopy was used to compare the morphologies of the fibers produced in both configurations in order to confirm whether a more uniform electric field yielded thinner fibers. The results show that the needle-plate configuration produced finer fibers than the parallel-plate configuration at all three spinning distances. However, there was no difference in the fiber diameters produced at the 12 and 15 cm spinning distances within the needle-plate configuration, implying thinning may only occur up to a certain distance in this configuration.

Indexed as

beadingelectric fieldelectrospinningparallel platescanning electron microscopysingle needle

Identifiers

PMID36677260
PMCPMC9864060

What OpenQuestion holds

Textmetadata
LicenceCC BY
Read underepoch 390

Registered trials

None linked

Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.