Surface Modification of 3D Printed Microfluidic Devices for Controlled Wetting in Two-Phase Flow.

Microfluidic devices (MFDs) printed in 3-D geometry using digital light projection to polymerize monomers often have surfaces that are not as hydrophobic as MFDs made from polydimethylsiloxane. Droplet microfluidics in these types of devices are subject to droplet adhesion and aqueous spreading on less hydrophobic MFD surfaces. We have developed a post-processing technique using hydrophobic monomers that renders the surfaces of these devices much more hydrophobic. The technique is fast and easy, and involves flowing monomer without initiator into the channels and then exposing the entire device to UV light that generates radicals from the initiator molecules remaining in the original 3-D polymerization. After treatment the channels can be cleared and the surface is more hydrophobic, as evidenced by higher contact angles with aqueous droplets. We hypothesize that radicals generated near the previously printed surfaces initiate polymerization of the hydrophobic monomers on the surfaces without bulk polymerization extending into the channels. The most hydrophobic surfaces were produced by treatment with an alkyl acrylate and a fluorinated acrylate. This technique could be used for surface treatment with other types of monomers to impart unique characteristics to channels in MFDs.