Article3D printing and additive manufacturing2022
Multiresin Additive Manufacturing Process for Printing a Complete Denture and an Analysis of Accuracy.
Article in 3D printing and additive manufacturing, 2022. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 3 papers.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
3 citing papers in PubMed, 9 citations in OpenAlex.
- [Short-term clinical outcomes of complete dentures fabricated by conventional and CAD/CAM milling techniques: A self-controlled study with randomized wearing sequence].Beijing da xue xue bao. Yi xue ban = Journal of Peking University. Health sciences · 2026Trial
- Impact of Printing Orientation on the Accuracy of Additively Fabricated Denture Base Materials: A Systematic Review.Dentistry journal · 2024Review
- Development of a Novel Tape-Casting Multi-Slurry 3D Printing Technology to Fabricate the Ceramic/Metal Part.Materials (Basel, Switzerland) · 2023Article
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
4 authors at 3 institutions in 2 countries.
Funding
No grant is acknowledged in the PubMed record.
Abstract
A complete denture, consisting of teeth and a gum base, is a standard device used to restore masticatory and esthetic functions in patients with complete edentulism. The different colors and mechanical properties for teeth and the gum base mean a complete denture is manufactured using two materials with different mechanical properties. This study proposes a method to make a complete denture using a laboratory-developed, multiresin additive manufacturing (MRAM) system with two resins and different mechanical properties. A tenon joint is used to create the bottom of the teeth that fit into the gum base, ensuring automatic alignment and higher bending strength. The mechanical properties, material waste, fabrication time, and effect of the tenon joint on the bending strength of a complete denture printed using the MRAM system are compared with the values for a computer-aided design and computer-aided manufacturing (CAD/CAM) system. Experimental results show that the printed denture is manufactured 3 times faster and produces 14 times less material waste, but is 35.08% less inaccurate than one produced using a CAD/CAM system. The proposed tenon joint increases the bending strength by 31.94%. The MRAM system is applicable for printing a complete denture.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.