ArticleHeliyon2022
The noise absorption prediction of a combined and independent absorber under different conditions and at different frequencies, using the new Engineering Noise Control Software (ENC).
Article in Heliyon, 2022. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
6 authors.
Funding
No grant is acknowledged in the PubMed record.
Abstract
Noise is one of the most harmful factors in the work environment, which is very important to control. There are various techniques to achieve this goal. One of the most important of them is the use of noise absorbers. Absorbent materials are often used to counteract the effects of reflected noise from hard surfaces and reduce their level. This is an experimental-applied study conducted in the physical factor laboratory of the Faculty of Health. The purpose was to predict the Noise absorption rate of combined and independent absorbers under different conditions and frequencies using the new ENC (engineering noise control) software. The sound absorption determination was carried out in 5 stages, including sound frequency analysis for the source, measurement of the dominant frequency, measurement of the absorption coefficient of absorbent materials in different conditions, measurement of the limit frequency (peak frequency of noise absorption) and comparison of the software results with the findings of the impedance tube in Real conditions. The best absorption mode for combined and independent absorbents is using a 5 cm rock wool absorbent with a 2 cm thick air layer behind it without a polyurethane absorbent layer and a 10 cm wide rock wool absorbent with a 1 cm air layer behind it without polyurethane layer. A polyurethane layer on the stone wool absorber decreased the amount of noise absorption for high frequencies. The results obtained from the best absorption conditions in the ENC software were consistent with the findings from the impedance tube device in real situations. The results of this study showed that suitable and optimal conditions of sound absorption could be achieved by using the ENC software, correct design, use of suitable absorbers, changes in the physical parameters of the absorber, and the use of a combined absorber.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.