An Analytical and Experimental Study on Cutting Characteristics and Transient Cutting Force Modeling in Feed Directional Ultrasonic Vibration-Assisted Cutting of High Strength Alloys.

Ultrasonic vibration-assisted cutting (UVC) is progressively being used in machining as it can significantly promote the fabrication process. However, the ultrasonic vibration affecting the cutting process is still controversial. The full-transient cutting process is proposed in this study to analyze the affecting mechanism induced by ultrasonic vibration in the cutting process. This novel model is the first developed based on the fact that ultrasonic vibration would change mechanical behaviors and the cutting process. For example, the reduction of shear flowing stress in the primary shear zone and alteration of the shear angle in the UVC process. Then, considering those coupled effects, a novel model is proposed to determine the average and transient cutting forces. Here, insight and understanding into the physical phenomenon in UVC are provided. The effectiveness of the proposed model is verified by comparison with experimental results and analytical models available in the literature, with cutting parameters varying from macro to micro-scale. The results show that the ultrasonic vibration affects the cutting process in a complicated way, which is determined by transient characteristics, acoustic softening, thermal softening, plowing, and friction. Those effects on cutting performances in the UVC process under various cutting scenarios are investigated and discussed systematically. The average deviation of cutting forces between experiments and values predicted by the proposed model for Ti6Al4V, AISI 1045, and Al6063 is about 7%, 10.2%, and 11%, respectively. The deviation decreases with the increase of cutting speed in the machining of Ti6Al4V, which is different from the machining of other materials. This is contributed by the varied effect of ultrasonic vibration on the cutting process.