Effects of demineralization mode and particle size of allogeneic bone powder on its physical and chemical properties.

At present, the commonly used allogeneic bone powder in the clinic can be divided into nondemineralized bone matrix and demineralized bone matrix (DBM). Commonly used demineralizers include acids and ethylene diamine tetraacetic acid (EDTA). There may be some diversities between them. Also, the size of the bone particle can affects its cell compatibility and osteogenic ability. We produced different particle sizes i.e., < 75, 75-100, 100-315, 315-450, 450-650, and 650-1000 μm, and treated in three ways (nondemineralized, demineralized by EDTA, and demineralized by HCl). Scanning electron microscopy showed that the surface of the samples in each group was relatively smooth without obvious differences. The results of specific surface area and porosity analysis showed that they were significantly higher in demineralized bone powder than in nondemineralized bone powder, however, there was no significant difference between the two decalcification methods. The content of hydroxyproline in nondemineralized bone powder and EDTA-demineralized bone powder had no statistical difference, while HCl-demineralization had statistical significance compared with the former two, and the content increased with the decrease of particle size. The protein and BMP-2 extracted from HCl demineralized bone powder were significantly higher than that from nondemineralized bone powder and EDTA demineralized bone powder, and there were differences among different particle sizes. These results suggested the importance of demineralization mode and particle size of the allogenic bone powder and provided guidance for the choice of the most appropriate particle size and demineralization mode to be used in tissue bioengineering.