ArticleHardwareX2022
Device for measuring part adhesion in FFF process.
Article in HardwareX, 2022. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 1 paper.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
1 citing paper in PubMed.
- Enhancing the Performance of FFF-Printed Parts: A Review of Reinforcement and Modification Strategies for Thermoplastic Polymers.Materials (Basel, Switzerland) · 2025Review
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
3 authors.
Funding
No grant is acknowledged in the PubMed record.
Abstract
The adhesion of parts to the build surface plays a central role in the Fused Filament Fabrication (FFF) process. Without sufficient adhesion, the part will deform (so called warping) due to thermal shrinkage, so that no defined geometries can be created. Nevertheless, there is no established method to measure the adhesion of printed parts and therefore it is not possible to targeted improve it. This article presents a measurement method based on the DIN EN 28510-1 standard and a corresponding test device which makes it possible to identify the optimum build surface for a filament and also to improve the process parameters in a targeted manner. The test device combines a FFF printer with a measuring unit so that all common filaments can be tested close to the process up to a processing temperature of 400 °C in the nozzle and around 150 °C on the build platform. The test device uses only open-source parts and software and costs about 1700€.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.