Load Sharing in the Femur Using Strut Allografts: A Biomechanical Study.

Background: Femoral strut allografts are used in revision hip arthroplasty for management of bone loss associated with implant failure or periprosthetic fractures. They have also been used to treat unremitting thigh pain in well-fixed cementless femoral stems, to address the differential in structural stiffness between the stem and femoral shaft. Our study used an in vitro biomechanical model to measure the effect of placement of allografts on femoral strains, to determine their load-sharing capacity. Material and methods: Three rosette strain gauges were applied to the femoral surface of each of 6 cadaveric femurs, at the stem tip level on anterior, medial, and lateral cortices. After stem implantation, cortical strut allografts were applied to the lateral femoral shaft and secured with 4 Dall-Miles cables. A fourth gauge was placed on the midpoint of the allograft. Strains were recorded in the intact femur, then the implanted femur with and without the allograft under simulated physiologic loading in a load frame. Results: Reduction in distal femoral principal strains, between 12% and 59%, was seen in all cortices following placement of the allograft. Under axial loading, 30% of the strain in the lateral cortex was borne by the allograft. Greater reductions in strain, by as much as 59%, occurred under axial load and torque. Conclusion: The results of this biomechanical model indicate that by placement of an allograft, cortical strains can be reduced to levels approaching those in an intact femur, supporting this technique for treatment of unremitting thigh pain in well-fixed prostheses.