ArticleMaterials (Basel, Switzerland)2022
Study of the Properties of Antifriction Rings under Severe Plastic Deformation.
Article in Materials (Basel, Switzerland), 2022. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 6 papers.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
6 citing papers in PubMed.
- Recyclable Materials for Ecofriendly Technology.Materials (Basel, Switzerland) · 2022Article
- Thermodynamic Simulation of Environmental and Population Protection by Utilization of Technogenic Tailings of Enrichment.Materials (Basel, Switzerland) · 2022Article
- Analysis of Stress-Strain State for a Cylindrical Tank Wall Defected Zone.Materials (Basel, Switzerland) · 2022Article
- Experimental Analysis of the Stress State of a Prestressed Cylindrical Shell with Various Structural Parameters.Materials (Basel, Switzerland) · 2022Article
- Development of a Thermomechanical Treatment Mode for Stainless-Steel Rings.Materials (Basel, Switzerland) · 2022Article
- Hardening of Bimetallic Wires from Secondary Materials Used in the Construction of Power Lines.Materials (Basel, Switzerland) · 2022Article
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
11 authors.
Funding
Abstract
The paper studies the properties of brass workpieces for antifriction rings under severe plastic deformation by high-pressure torsion. The evolution of microstructure and mechanical properties of deformed workpieces after six cycles of deformation by high-pressure torsion at 500 °C have been studied. All metallographic studies were performed using modern methods: transmission electron microscopy (TEM) and analysis electron back scatter diffraction patterns (EBSD). The deformation resulted in an ultrafine grained structure with a large number of large-angle boundaries. The strength properties of brass increased compared to the initial state almost by three times, the microhardness also increases by three times, i.e., increased from 820 MPa in the initial state to 2115 MPa after deformation. In this case, the greatest increase in strength properties occurs in the first two cycles of deformation.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.