Prediction of quality attributes (mechanical strength, disintegration behavior and drug release) of tablets on the basis of characteristics of granules prepared by high shear wet granulation.

High shear wet granulation is commonly applied technique for commercial manufacturing of tablets. Granulation process for tablets manufacturing is generally optimized by hit and trial which involves preparation of granules under different processing parameters, compression of granules and evaluation of the resultant tablets; and adjustment is made in granulation process on the basis of characteristics of tablets. Objective of the study was to optimize the process of high shear wet granulation and prediction of characteristics of tablets on the basis of properties of granules. Atenolol granules were prepared by high shear wet granulation method, using aqueous solution of polyvinyl pyrrolidone (PVP k-30) as binder. Concentration of binder solution and granulation time were taken as process variables, both studied at three levels. Different combinations of process variables were determined by Design Expert software. Granules were evaluated for different parameters on the basis of SeDeM-ODT (Sediment Delivery Model-Oro Dispersible Tablets) expert system. Granules from all the trials were compressed using round (10.5 mm) flat faced punches at compression weight of 250 mg/tablet. Tablets were evaluated of different quality control parameters as per USP. Results showed that both the process variables had positive effect on mechanical strength of tablets and negative effect on disintegration and dissolution rate. Granule prepared with highest level of binder concentration (15%) and highest granulation time (60 sec) resulted in tablets with highest crushing strength (11.8 kg), specific crushing strength (0.328 kg/mm2), tensile strength (0.208 kg/mm2), lowest value of friability (0.19%) and highest disintegration time (10.9 min), as predicted from granules characteristics on the basis of SeDeM-ODT expert system. Drug release from Trial-13 (processed under highest level of both process parameters) was also lower than rest of the trials. It is concluded from the study that quality characteristics of tablets can be predicted from granules characteristics using SeDeM-ODT expert system. Furthermore, SeDeM-ODT expert system can also be used for optimization of the process of high shear wet granulation.