Low-Roughness-Surface Additive Manufacturing of Metal-Wire Feeding with Small Power.

Bobo Li, Bowen Wang, Greg Zhu, Lijuan Zhang, Bingheng Lu

Abstract read

In one paragraph

Article in Materials (Basel, Switzerland), 2021. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 1 paper.

0numbers the graph read from it

0cells of the map it votes in

1citing papers in PubMed

–field-weighted citation impact

1 · What the graph read from it

What it found

Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.

The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.

2 · The registry

The trial behind it

Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.

Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.

3 · Its place in the literature

Who cites it

1 citing paper in PubMed.

Study on the Process Characteristics Based on Joule Heat of Sliding-Pressure Additive Manufacturing.Materials (Basel, Switzerland) · 2023
Article

4 · The record

Corrections and comments

PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.

5 · Who and what money

Authors and funding

5 authors.

Bobo LiSchool of Mechanical Engineering, Xi'an Jiaotong University, Xi'an 710049, China.ORCID 0000-0001-6288-2959

Bowen WangSchool of Mechanical Engineering, Xi'an Jiaotong University, Xi'an 710049, China.

Greg ZhuNational Innovation Institute of Additive Manufacturing, No. 997, Shanglinyuan 8th Road, Gaoxin District, Xi'an 710300, China.

Lijuan ZhangNational Innovation Institute of Additive Manufacturing, No. 997, Shanglinyuan 8th Road, Gaoxin District, Xi'an 710300, China.ORCID 0000-0001-7824-8514

Bingheng LuSchool of Mechanical Engineering, Xi'an Jiaotong University, Xi'an 710049, China.

Funding

Guangdong Basic and Applied Research Foundation 2019B1515130005Key Research and Development Program of Shaanxi province 2021GY-300

6 · The paper itself

Abstract

Aiming at handling the contradiction between power constraint of on-orbit manufacturing and the high energy input requirement of metal additive manufacturing (AM), this paper presents an AM process based on small-power metal fine wire feed, which produces thin-wall structures of height-to-width ratio up to 40 with core-forming power only about 50 W. In this process, thermal resistance was introduced to optimize the gradient parameters which greatly reduces the step effect of the typical AM process, succeeded in the surface roughness (

Indexed as

additive manufacturingdirect metal depositionfine metal wirelaser and Joule heatingsurface roughnesswire feed

Identifiers

PMID34361458

DOI10.3390/ma14154265

PMCPMC8348733

What OpenQuestion holds

Textmetadata

LicenceCC BY

Read underepoch 390

Registered trials

None linked

Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.