ArticleMaterials (Basel, Switzerland)2021
Influence of the Undercut Anchor Head Angle on the Propagation of the Failure Zone of the Rock Medium-Part II.
Article in Materials (Basel, Switzerland), 2021. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Not yet cited in PubMed.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
0 citing papers in PubMed.
No citing paper in PubMed yet.
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
3 authors.
Funding
Abstract
Problems concerning the influence of the geometric parameters of an undercutting anchor on the range of the failure zone of rock medium during the pulling out of the anchor constitute one of the aspects that arouse the interest of authors due to attempts to use undercutting anchors in the process of rock lump separation. This method is considered an alternative to the existing methods of separation, especially in special cases of mining technologies. This article presents the results of numerical investigations into the effect of changes in the head geometry that occur as a result of wear on the conical part of the undercutting anchor and the extent of failure of the rock medium during its pulling out. This is an extension of considerations presented in previous work, where special attention was paid to the influence of potential errors in anchor installation, leading to changes in head geometry and, consequently, to changes in the extent of the failure zone of the rock medium. As a result, significant changes in the volume of the detached rock masses are observed. This study shows that the increasing surface friction of the stripping anchor head leads to a decrease in the angle of the undercutting head. As a result, the extent of the failure zone measured on the free rock surface increases, the value of the angle of the failure cone at the initial stage of the stripping decreases, and the deformation of rock in the plane perpendicular to the anchor axis increases.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.