Two-stage continuous production process for fatty acid methyl ester from high FFA crude palm oil using rotor-stator hydrocavitation.

Two-stage continuous production process for fatty acid methyl ester (FAME) from crude palm oil was performed using the rotor-stator hydrocavitation reactor. The novel ABS filament printed rotor having spherical holes on the surface of the rotor which is an efficient, fast and cost-effective procedure, was installed in the stainless steel stator of hydrosonic reactor. The 3D printed hydrosonic reactor was used to treat the FFA-rich in MCPO by esterification and followed by transesterification to produce the methyl ester. The optimum conditions of both esterification and transesterification processes were determined using the response surface methodology (RSM). For the 1st step esterification, the conditions of methanol 17.7 vol%, sulfuric acid 2.9 vol%, 3000 rpm rotor speed, hole's diameter and depth 4 and 6 mm, and 25 L/h MCPO, were used for decreasing the FFA from 11.456 to 1.028 wt%. For the 2nd step, transesterification was employed with the optimal condition of 28.6 vol% methanol, 6.2 g/L of potassium hydroxide, 3000 rpm rotor speed, the dimension of the spherical holes on the rotor's surface having diameter of 6.4 mm and 6.2 mm in depth, and esterified oil flow rate 25 L/h, for producing the methyl ester to over 99.163 wt%. Moreover, the purified biodiesel yields and the average energy consumption for the entire two-stage continuous process between hydrosonic and ultrasonic clamp reactors were compared. The results of purified methyl ester clearly indicate that the methyl esters of 99.163 wt% and 97.814 wt% were achieved from hydrosonic and ultrasonic clamp reactors, respectively, under the same optimized conditions. The maximum yields of purified biodiesel were 97.51 vol% and 88.69 vol% using hydrosonic and ultrasonic clamp reactors, respectively. The average energy consumption for the entire continuous two-stage process for both hydrosonic and ultrasonic clamp reactors were 0.049 and 0.056 kW h/L, respectively. For practical industrial processes, stainless steel rotors inside the stator was manufactured by CNC machine, which was also verified under the optimum conditions. The results showed that 1.07 wt% FFA and 99.221 wt% methyl ester of were obtained from first step and second step, respectively.