ArticleMaterials (Basel, Switzerland)2020
Research into the Effect of Grain and the Content of Alundum on Tribological Properties and Selected Mechanical Properties of Polymer Composites.
Article in Materials (Basel, Switzerland), 2020. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 7 papers.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
7 citing papers in PubMed.
- Dimensional Accuracy After Precision Milling of Magnesium Alloys Using Coated and Uncoated Cutting Tools.Materials (Basel, Switzerland) · 2024Article
- Influence of Citrus Fruit Waste Filler on the Physical Properties of Silicone-Based Composites.Materials (Basel, Switzerland) · 2023Article
- Multiobjective Optimization of Composite Wind Turbine Blade.Materials (Basel, Switzerland) · 2022Article
- The Mechanical and Tribological Properties of Epoxy-Based Composites Filled with Manganese-Containing Waste.Materials (Basel, Switzerland) · 2022Article
- Determination of Mechanical and Tribological Properties of Silicone-Based Composites Filled with Manganese Waste.Materials (Basel, Switzerland) · 2021Article
- Mechanical, Chemical, and Processing Properties of Specimens Manufactured from Poly-Ether-Ether-Ketone (PEEK) Using 3D Printing.Materials (Basel, Switzerland) · 2021Article
- The Influence of Zinc Waste Filler on the Tribological and Mechanical Properties of Silicone-Based Composites.Polymers · 2021Article
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
3 authors.
Funding
Abstract
The subject of the research is a polymer composite with a matrix base of epoxy resin L285 cured with H285 hardener, and a physical modifier of friction in the form of alundum. The article presents an analysis of findings of tribological examinations. The authors evaluated the influence of the modifier properties in the form of alundum, i.e., mass share and grain size, on the abrasive wear of a composite, defined as loss of weight as well as on roughness parameters and selected mechanical properties. The tribological examinations have been extended by measurements of hardness and density of the prepared composites. The obtained results of tribological examinations showed an increase in the average value of weight loss in relation to the loss of sample weight loss between the cycles. The influence of both the grain size and the mass percentage share of alundum upon the increase in the longitudinal modulus of elasticity was also observed. On the basis of the obtained results, it was found that alundum of grain sizes equal to F220 and F240 exerted the best influence on the reduction of abrasive wear of the tested samples. In the case of F220, it was 14.04% of the average value of the weight loss between the cycles for all percentage shares of the used grains.
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.