ArticleMaterials (Basel, Switzerland)2020
Reduction of Power Consumption by Chip Breakability Control in Ti6Al4V Titanium Alloy Turning.
Article in Materials (Basel, Switzerland), 2020. The graph could read no effect estimate from its abstract, so it casts no vote on the map. Cited by 3 papers.
What it found
Each row is one number read from the abstract, on the scale the paper reported it, with its interval. Left of the dashed line favours the treatment, right favours the comparator. Under each row is the sentence it came from. New to these charts? A ten-minute tutorial.
The abstract states no effect estimate the extractor could read, or names no intervention and outcome on the map, so this paper lights no cell and moves no belief. It is still indexed, cited and linked below.
The trial behind it
Trials whose registry record cites this paper, or whose number appears in the abstract. A trial that started after this paper was published is citing it as background, not reporting it.
Neither the registry nor the abstract names a trial number. If this is a trial report, that itself is worth knowing.
Who cites it
3 citing papers in PubMed.
- Achieving precise chip control for high-end manufacturing.Scientific reports · 2026Article
- Influence of Technological Parameters on Chip Formation and Chip Control in Precision Hard Turning of Ti-6Al-4V.Micromachines · 2023Article
- Optimization of Titanium Alloy Drilling to Minimize the Secondary Burr after Deburring Process.Materials (Basel, Switzerland) · 2022Article
Corrections and comments
PubMed lists nothing against this paper. Absence here is not a guarantee, only a check that was made.
Authors and funding
3 authors.
Funding
No grant is acknowledged in the PubMed record.
Abstract
The paper concerns the problem of energy savings in turning of titanium alloy Ti6Al4V. Since this alloy belongs to difficult to cut materials, there is a problem with chip forming and breaking. The turning process is often supported by implementing a high-pressure cooling (HPC) system. Based on the observations and the adopted chip classification method, the authors proved that it is not necessary to use this method in roughing operations, however it helps with the chips breaking process in finishing operations. A general algorithm for machining optimization due to the chip geometry is presented and described. In the presented case, it was shown that the acceptable chip geometry could be obtained with a reduced power consumption by approximately
Indexed as
Identifiers
What OpenQuestion holds
Registered trials
Read under generation 80e0d062 · epoch 390. Bibliography from PubMed, PubMed Central and OpenAlex; grants from NIH RePORTER; trial links from ClinicalTrials.gov; estimates, votes and beliefs from the OpenQuestion graph.