Base-catalysed decomposition of polychlorinated biphenyls in transformer oils by mixture of sodium hydroxide, glycerol and iron.

In this research, a method based on base-catalysed decomposition (BCD) was developed using sodium hydroxide and glycerol for dechlorination of transformer oils with low levels of polychlorinated biphenyls (PCBs). PCB removal and dechlorination efficiencies were measured by gas chromatography and the silver nitrate titration method, respectively. PCB dechlorination and removal efficiencies after 4 h at 250°C and in the presence of iron were 97.4% and 99.8%, respectively. However, in the absence of iron the same efficiencies were calculated to be 79.4 and 99.7%, respectively. The dielectric loss factor of oil refined at 250°C was 0.0064 and did not meet the required standards to be reused in the transformers. However, that refined at 200°C satisfied the standards with acceptable conversion rates. Use of iron, besides increasing conversion rates, changed the mechanism of the reaction from nucleophilic substitution to a combination of hydrodechlorination and nucleophilic substitution. In the presence of iron, highly chlorinated PCBs were converted to less chlorinated PCBs, and this caused the concentration of less chlorinated PCBs to reach a peak and then decline thereafter. The production of PCB 36 confirmed this. However, in the absence of iron particles, all changes in the PCB concentration curves were downward.